| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Exterior Panels/Trim | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000033QK002X |
| Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
1. INSTALL FRONT BUMPER COVER
|
(a) Engage the 4 claws and install the front bumper cover. |
(b) Connect the connectors.
HINT:
If vehicle equipped with fog lights or ultrasonic sensors, connect the connectors.
|
(c) Install the 8 clips. |
(d) Tighten the 7 screws.
|
(e) Install the 2 pin hold clips. HINT:
Use the same procedure for the RH side and LH side. |
(f) Install the clip.
HINT:
Use the same procedure for the RH side and LH side.
(g) Install the screw.
HINT:
Use the same procedure for the RH side and LH side.
2. INSTALL FRONT END PANEL LH (w/o Headlight Cleaner System)
3. INSTALL FRONT END PANEL RH (w/o Headlight Cleaner System)
HINT:
Use the same procedure as for the LH side.
4. INSTALL FRONT END PANEL LH (w/ Headlight Cleaner System)
5. INSTALL FRONT END PANEL RH (w/ Headlight Cleaner System)
HINT:
Use the same procedure as for the LH side.
6. PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT
7. PREPARE FOR HEADLIGHT AIMING (for Using a Tester)
8. PREPARE FOR HEADLIGHT AIMING (for Using a Screen)
9. INSPECT HEADLIGHT AIMING
10. ADJUST HEADLIGHT AIMING
11. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT
12. PREPARE FOR FOG LIGHT AIMING
13. INSPECT FOG LIGHT AIMING
14. ADJUST FOG LIGHT AIMING
|
|